![]() In this example Programming Port will be used for programming and EtherCAT Master will be used to connect to IO. To do this, right-click on a NIC and select Rename. A helpful (but optional) step is to rename each NIC to describe its purpose. ![]() Before you proceed, identify which NIC you will be using for each purpose and the IP addresses that you’d like to assign to these NICs. There are often two (though there may be more or less) - one that you can use to connect a programming computer and another that can be used to connect to IO racks/devices. This window should display the Network Interface Connections (NICs) available on your Beckhoff IPC. First, open up the IPC’s adapter settings by right-clicking on the Network Icon in the system tray and selecting “Open Network & Internet settings” (or “Open Network and Sharing Center” (Windows 7)).įrom this window, select “Change adapter options” (“ Change adapter settings” on the left side of the window in Windows 7). To get started with the setup, first, we need to do some basic network setup. For a basic setup, you can step through the wizard with default options, and on the last page uncheck the box that says “Run Beckhoff Security Wizard on next startup” so it won’t run on future startups. If your device is a Beckhoff IPC, Beckhoff Device Manager will probably run on startup. Programming happens on this device, as well as some of the configuration of the Beckhoff IPC. "Programming Computer" - a computer, such as an engineer's laptop, where the TwinCAT XAE development environment is installed.Device configuration will occur on this device. "Beckhoff IPC" - the hardware, likely obtained from Beckhoff, that will run the PLC and HMI server.For clarity, those devices are as follows: Throughout this blog series, I refer to two devices repeatedly. Install the Beckhoff Real-Time Ethernet Driver.Install TwinCAT Runtime, HMI Server, and Google Chrome.Download TwinCAT Runtime, HMI Server, and Google Chrome.The screenshots in the instructions below are from Windows 10, but I will include Windows 7 instructions if they differ. Note: if you’re not using the TC3 HMI, you can disregard the steps involving it. This blog series has compiled those steps into a general format for anyone who might need to do the same, from Basic Device Setup to PLC configuration, and to HMI configuration. Since we had multiple IPCs to get out to our customer, the DMC team compiled a list of the steps needed to take a basic IPC with no programs installed to a fully functioning Beckhoff PLC/HMI. ![]() Recently I was working on a project with several Beckhoff IPCs. This is the first installment of a three-part blog series covering all you need to know about getting started with a Beckhoff PLC/HMI. In this blog, we'll be covering how to initially set up your Beckhoff IPC to run PLC code and a TCHMI server. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |